Agilent Technologies 4294A Programming Manual

Chapter 16 371
GPIB Command Reference
OUTEIO
16. GPIB
Command Reference
( O - R )
OUTEIO
Syntax OUTEIO <numeric>
Description If input/output port E (port C + port D) of the 24-bit I/O port has been set to an output port
(by the execution of the
“COUT” command on page 283 and “DOUT” command on page
307), outputs data to port E. Data is outputted as 8-bit binary, assuming that C0 is LSB and
D3 is MSB. If port C or port D is set to an input port, executing this command causes an
error and the command is ignored. This command has the same function as the WRITEIO
16,4 command of Instrument BASIC. (No query)
Parameters
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Corresponding
key
No front panel key is available to execute this function.
OUTFIO
Syntax OUTFIO <numeric>
Description Outputs data to output port F (port A + port B) of the 24-bit I/O port. Data is outputted as
16-bit binary, assuming that A0 is LSB and B7 is MSB. This command has the same
function as the WRITEIO 16,5 command of Instrument BASIC. (No query)
Parameters
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Corresponding
key
No front panel key is available to execute this function.
<numeric>
Description Output data
Range 0 to 255
Resolution 1
<numeric>
Description Output data
Range 0 to 65535
Resolution 1

Agilent Technologies 4294A Specifications

General

Brand	Agilent Technologies
Model	4294A
Category	Measuring Instruments
Language	English