Agilent Technologies 4294A Programming Manual

Chapter 16 265
GPIB Command Reference
ADDRIP
16. GPIB
Command Reference
( * , A - E )
ADDRIP
Syntax ADDRIP <1st>,<2nd>,<3rd>,<4th>
ADDRIP?
Description Sets the LAN IP address of the 4294A when using the 4294A connected to LAN.
NOTE To bring the setting of the changed IP address to take effect, reboot (turn off and then on
again) the 4294A after the setting.
Parameters
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response {1st},{2nd},{3rd},{4th}<newline><^END>
Corresponding
key
[Local] - IP ADDRESS - 1st, 2nd, 3rd, 4th
<1st>
*1
<2nd>
*1
<3rd>
*1
<4th>
*1
Description 1st number of IP
address
2nd number of IP
address
3rd number of IP
address
4th number of IP
address
Range 0 to 255 0 to 255 0 to 255 0 to 255
Initial value 0 0 0 0
Resolution 1 1 1 1
*1.For example, if the IP address is 1.10.100.50, <1st> is 1, <2nd> is 10,
<3rd> is 100, and <4th> is 50.

Agilent Technologies 4294A Specifications

General

Brand	Agilent Technologies
Model	4294A
Category	Measuring Instruments
Language	English