Chapter 16 335
GPIB Command Reference
LIMSTEST
16. GPIB
Command Reference
( F - N )
LIMSTEST
Syntax LIMSTEST {ON|OFF|1|0}
LIMSTEST?
Description In the creation/edit of the limit line table for the active trace (set with the “TRAC”
command on page 457), toggles on and off the limit test function for each segment.
If segment creation/edit has not been started, executing this command automatically starts
the edit of the edit target segment and then turns on/off the function.
If the creation/edit of the limit line table has not been started, executing this command
automatically starts table creation/edit, starts the edit of the edit target segment, and then
turns on/off the function.
Parameters
Query response {1|0}<newline><^END>
Corresponding
key
[System] - LIMIT TEST - EDIT LIMIT LINE - EDIT - more 1/3 - more 2/3 - TEST on OFF
Description
ON or 1 (initial value) Turns on the segment limit test function.
OFF or 0 Turns off the segment limit test function.
To Next Page
Loading...
Need help?
General
