346 Chapter 16
GPIB Command Reference
MANR
MANR
Syntax MANR <value 1>,<value 2>
MANR?
Description When the manual sweep function is on, sets a measurement range. You need to turn on the
manual sweep with the
“MANS”(347page) command before executing this command.
Parameters
NOTE When both <value 1> and <value 2> are 0, the measurement range for the manual sweep is
set to the measurement point specified with the “MANP” on page 345 command.
Only when the specified parameters satisfy the condition value 1 < value 2, the sweep
range is set properly. If this condition is not satisfied, the following occurs.
Query response {value 1},{value 2}<newline><^END>
Equivalent key No equivalent key is available on the front panel.
<value 1> <value 2>
Description The number of the sweep start
point
The number of the sweep stop
point
Measurement point numbers are assigned in order from the left
end assuming that the left end measurement point is 1.
Range 1 to the number of measurement points or both <value 1> and
<value 2> are 0.
Preset value 0 0
Resolution 1 1
Condition Change of setting
value ≤ 0 When both value 1 and value 2 are 0, they do not change. The
sweep is performed for the point specified with the
“MANP”(345page) command.
Otherwise, 1 is set.
value > the number
of measurement
points
The value is set to the number of measurement points.
value 1 ≥ value 2 Value 1 is set to the value of value 2. The sweep is performed for
the point specified with the
“MANP”(345page) command.
To Next Page
Loading...
Need help?
General
