Agilent Technologies 4294A Programming Manual

468 Chapter 16
GPIB Command Reference
:PROGram[:SELected]:WAIT
:PROGram[:SELected]:WAIT
Syntax :PROGram[:SELected]:WAIT
:PROGram[:SELected]:WAIT?
Description Makes the setting so that the 4294A accepts no commands until the status of the program
on the 4294A Instrument BASIC editor becomes STOP or PAUSE from RUN.
If this command is executed as Query, 1 is read out when the program status changes from
RUN to STOP or PAUSE.
Query response {1}<newline><^END>
Corresponding
key
No front panel key is available to execute this function.
Commands starting with :PROGram:EXPLicit
The commands starting with :PROGram:EXPLicit have the same function as those starting
with :PROGram[:SELected]. The below table shows their relationship.
If you change the definition of the program name with the
“:PROGram[:SELected]:NAME” command on page 466, the “PROG” part in the table
must be replaced with the program name.
Commands starting with
:PROGram:EXPLicit:
Commands starting with
:PROGram[:SELected]:
:PROGram:EXPLicit:DEFine "PROG" :PROGram[:SELected]:DEFine
:PROGram:EXPLicit:DELete "PROG" :PROGram[:SELected]:DELete:[SELected]
:PROGram:EXPLicit:EXECute "PROG" :PROGram[:SELected]:EXECute
:PROGram:EXPLicit:MALLocate "PROG" :PROGram[:SELected]:MALLocate
:PROGram:EXPLicit:NAME "PROG" :PROGram[:SELected]:NAME
:PROGram:EXPLicit:NUMBer "PROG" :PROGram[:SELected]:NUMBer
:PROGram:EXPLicit:STATe "PROG" :PROGram[:SELected]:STATe
:PROGram:EXPLicit:STRing "PROG" :PROGram[:SELected]:STRing
:PROGram:EXPLicit:WAIT "PROG" :PROGram[:SELected]:WAIT

Agilent Technologies 4294A Specifications

General

Brand	Agilent Technologies
Model	4294A
Category	Measuring Instruments
Language	English