Chapter 3 43
Setting Measurement Conditions
Setting Averaging
1. Chapter Title
2. Chapter Title 3. Setting Measurement
4. Chapter Title
5. Chapter Title
Conditions
Setting Averaging
Setting a measurement bandwidth
To set a measurement bandwidth, use the command given below.
• “BWFACT” on page 274
Setting averaging
Setting sweep averaging
To set or control sweep averaging, use the command given below.
• “AVER” on page 269
• “AVERFACT” on page 269
• “AVERREST” on page 269
Setting point averaging
To set point averaging, use the commands given below.
• “PAVER” on page 396
• “PAVERFACT” on page 396
To Next Page
Loading...
Need help?
General
