Chapter 16 347
GPIB Command Reference
MANS
16. GPIB
Command Reference
( F - N )
MANS
Syntax MANS {ON|OFF|1|0}
MANS?
Description Turns on/off the manual sweep function.
Parameters
Query response {1|0}<newline><^END>
Corresponding
key
[Sweep] - MANUAL SWP on OFF
MAXDCV
Syntax MAXDCV <numeric>[V]
MAXDCV?
Description Sets the voltage limit maximum value when the dc bias output mode is the constant-voltage
mode or constant-current mode (CVOLT or CCURR has been specified with the
“DCMOD” command on page 291).
Parameters
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response {numeric}<newline><^END>
Corresponding
key
[Source] - BIAS MENU - MAX LIMIT VORTAGE
Description
ON or 1 Turns on the manual sweep function.
OFF or 0 (initial value) Turns off the manual sweep function.
<numeric>
Description Voltage limit maximum value of the dc bias output
Range -40 to 40
Initial value 40
Unit V (volt)
Resolution 1E-3
To Next Page
Loading...
Need help?
General
