Chapter 16 275
GPIB Command Reference
CALECPARA
16. GPIB
Command Reference
( * , A - E )
CALECPARA
Syntax CALECPARA
Description Executes the equivalent circuit analysis depending on the equivalent circuit model
specified with the
“EQUC” command on page 311, and displays the analysis result
(equivalent circuit parameters). The analysis range is the same as that of the marker search
function. (No query)
Corresponding
key
[Display] - more 1/2 - EQUIV CKT - CALCULATE PARAMETERS
CALP
Syntax CALP {FIXED|USER}
CALP?
Description Specifies which measurement points are used for user calibration data and fixture
compensation data: (fixed) measurement points provided by the 4294A or user created
measurement points (measurement points in the sweep setting at the execution of
calibration/compensation).
Parameters
Query response {FIXED|USER}<newline><^END>
Corresponding
key
[Cal] - COMP POINT [ ]
CALQUI
Syntax CALQUI
Description Aborts the measurement of user calibration data. (No query)
Corresponding
key
[CAL] - USER CAL - EXCUTE CAL - cancel
CALS
Syntax CALS
Description Lists the set values of the user calibration kit (values entered with the
“DCALOPEN{G|C}”(288page), “DCALSHOR{R|L}”(289page), and
“DCALLOAD{R|L}”(287page) commands). (No query)
Corresponding
key
[Copy] - SELECT CONTENTS - CAL KIT VALUE
Description
FIXED
(Initial value)
Uses the (fixed) measurement points provided by the 4294A.
USER Uses the user created measurement points.
To Next Page
Loading...
Need help?
General
