Chapter 16 437
GPIB Command Reference
SETCTIME
16. GPIB
Command Reference
( S - Z , :PROG )
SETCTIME
Syntax SETCTIME <hour>,<min>,<sec>
SETCTIME?
Description Sets the time of the built-in clock of the 4294A.
Parameters
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response {hour},{min},{sec}<newline><^END>
Corresponding
key
[System] - CLOCK - TIME 
SIMFCHAR
Syntax SIMFCHAR
Description Executes the simulation of the frequency characteristic of the equivalent circuit. (No
query)
Corresponding
key
[Display] - more 1/2 - EQUIV CKT - SIMULATE F-CHRST
SING
Syntax SING
Description Performs a single sweep. After the sweep, the sweep mode goes to HOLD. (No query)
Corresponding
key
[Trigger] - SINGLE
<hour> <min> <sec>
Description Time (24 hours) Minute Second
Range 0 to 23 0 to 59 0 to 59
Resolution 1 1 1
To Next Page
Loading...
Need help?
General
