shows only status.
ES: Inserts one or more errors in one second (Errored Second).
Insert icon shows only status.
SES: Inserts 30% or less errors in one second (Severely Errored
Second). The Error Insert icon shows only status.
2. Select the Error destination.
3. Touch the Error burst length field to set the errors insertion counts.
5.3.4.2 PDH frequency
PDH frequency is available when without SDH layer or SONET layer. Touch
the field to set Frequency Offset. If setting a positive value, the frequency
will shift higher side.
Example:
If setting 20 ppm to the frequency offset for E1 output signal, the bit rate
of output signal will be
2 048 * (1+20*10
-6
) = 2 048.041 (kbit/s).
5.4 DS1/J1 Setup and Status
To Next Page
Loading...
