This screen allows you to configure the following parameters related to an
RFC 2544 Throughput and Frame Loss test:
Frame Size
Line Load
Duration
The settings for 'Throughput and Frame Loss' are identical to the ones
described in the Throughput section above.
6.9.2.5 Latency
Only available if you have specified a Latency test on the 'Control' of the the Test
Setup screen.
Touching the Latency button in the navigation area will display the screen
shown below.
This screen allows you to configure the parameters related to an RFC 2544
Latency test:
Frame Size
Line Load
Duration
To Next Page
Loading...
