3.5.8 Stand-alone Editor
MX100001A Editor allows users to load, edit, and save Setup files of any
possible Network Master configuration, without connecting to an actual
instrument.
1. Click Start > All Programs > Anritsu > MX100001A folder.
2. Click MX100001A-V*.**-Editor.
3. Set configuration of Network Master by clicking options in Select
Controller, Select First Module, and Select Second Module.
To save the configuration, click Save Configuration.
4. Click OK. After a while, the GUI of the selected Network Master
configuration appears.
5. Select an application, select port resources, and configure settings and
measurement parameters.
6. Once done, save the setup file by clicking Load/Save on Application
Toolbar.
Load the Setup File saved by the MX100001A Editor on the Network Master
by clicking Load/Save button on the Application Toolbar. Alternatively,
import the settings file as a Favorite, and launch the new application from the
Favorites screen on the Application Selector.
3.6 Command-Based Remote Control
To Next Page
Loading...
