the "X" symbol in the upper right-hand corner of the keypad.
4.1.6 User Pattern Editor
The 32-bits and 2048-bits user patterns are specified using the Pattern
Editor. You can view the pattern in either Hexadecimal, Binary or ASCII
format and use either a numpad, an ASCII table or a keyboard to set it up.
You use the numpad to edit the pattern in the Hex and Bin view modes, and
use either the ASCII table or the keyboard to edit in ASCII view mode.
For 2048-bits user patterns, you can use the Line Width drop-down menu
to specify how the pattern is displayed. The available values are: 2, 4, 8, 16,
32, 64 bytes.
4.1.7 Prompts to Confirm Dependencies
When a parameter change spawns changes elsewhere because of
dependencies, you are prompted to accept or reject the change(s). A
Confirm Dependencies dialog box is displayed, with information about the
dependency-related changes.
You can switch whether displaying the Confirm Dependencies dialog box.
Refer to Miscellaneous in "Instrument Toolbar" section.
4.2 Toolbars
To Next Page
Loading...
