Terminology
Headers
WAN
Select the Enable check box to enable insertion of the WAN interface
sublayer (WIS).
WAN interface sublayer is available for BERT application only.
6.1.2 Ethernet Frame Setup
6.1.2.1 WAN
Touching the WAN button in the navigation area will display the screen
shown below.
This screen allows you to specify the configuration of a WAN interface
sublayer for the currently selected Ethernet port. It can also be used to
inspect the current status of the selected port.
The configuration options available in the setup area of the screen are
described below. The status information is described in a separate section.
Allows you to select either Sonet or SDH notation for the naming of alarms,
errors, and pointers on the WAN status and result pages.
The buttons varies depending on "Terminology" selection. Touching the
buttons launches the dialog box to set SOH, TOH or POH.
SOH (Section OverHead) for SDH
TOH (Transport OverHead) for Sonet
POH (Path Overhead)
For the operation of dialog boxes, refer to the following sections.
SOH Editor in "SDH Setup and Status"
POH Editor in "SDH Setup and Status"
TOH Editor in "SONET Setup and Status"
POH Editor in "SONET Setup and Status"
It is possible to let the Port 2 copy the setup from Port 1 by touching the Follow
button. When this button is displayed in green, Port 2 continues to follow Port 1
change. This button appears when the Port 1 settings can be copy to Port 2.
6.1.2.2 Stream
Touching the Stream button in the navigation area will display a screen like
the one shown below.
To Next Page
Loading...
