The pop-up dialog box shows the current GPS status, and, for purely
informational purposes, the number of satellites used for position fix, and the
current geolocation of the GPS receiver, in degrees and decimal minutes
format.
3.10 Remote Control via GPIB
Using a J1667A GPIB-USB Conver, an optional accessory, allows users to
control Network Master via GPIB. GPIB address of Network Master can be set
in the Remote Control.
Command-Based Remote Control is available via GPIB control. MX100001A
MT1000A/MT1100A Control Software does not support operation via GPIB.
To Next Page
Loading...
