1.4 Warnings
This section contains warnings which should be followed to avoid personal
injury, product damage, as well as damage to the environment.
WARNING
ALWAYS refer to the operation manual when working near locations at
which the alert mark shown on the left is attached. If the advice in the
operation manual is not followed, there is a risk of personal injury or
reduced equipment performance. The alert mark shown on the left may
also be used with other marks and descriptions to indicate other
dangers.
Overvoltage Category
This equipment complies with overvoltage category II defined in IEC
61010. DO NOT connect this equipment to the power supply of
overvoltage category III or IV.
Laser radiation warning
NEVER look directly into the cable connector on the equipment nor into
the end of a cable connected to the equipment. There is a risk of injury if
laser radiation enters the eye.
The Laser Safety label is attached to the equipment for safety use as
indicated in "Laser Safety".
Repair Only qualified service personnel with a knowledge of electrical fire and
shock hazards should service this equipment. This equipment cannot be
repaired by the operator. DO NOT attempt to remove the equipment
covers or unit covers or to disassemble internal components. In addition,
there is a risk of damage to precision components.
Calibration The performance-guarantee seal verifies the integrity of the equipment.
To ensure the continued integrity of the equipment, only Anritsu service
personnel, or service personnel of an Anritsu sales representative,
should break this seal to repair or calibrate the equipment. Be careful
not to break the seal by opening the equipment or unit covers. If the
performance-guarantee seal is broken by you or a third party, the
performance of the equipment cannot be guaranteed.
WARNING
To Next Page
Loading...
