Adding devices
manually
Devices will appear in the dialog's list as they are discovered. Select the
device in the list and touch the Add button in the dialog box. The device is
added to the list displayed on the Discovery view screen.
To add devices manually, touch the Add button on the left side of the
Discovery view screen. This will launch the Add Rmp dialog box where you
can enter identification data for a specific remote device.
The Add Rmp dialog box contains the following parameters:
Domain
Allows you to specify the MD to which the MEP belongs. You can set the
domain when 802.1ag is selected.
MEG ID
Allows you to specify the MEG to which the MEP belongs.
Level
Use the drop-down menu to select the MD level at which the MEP exists.
MEP ID
Allows you to specify the Maintenance Point ID that the unit will be known as
in the MA. Note that this is the only required parameter.
MAC
Allows you to specify the MAC address of the remote unit.
To Next Page
Loading...
