Touching the Mapping button in the upper left-hand corner of the Ports
Setup screen launches the dialog box shown below.
This dialog box allows you to define OTUk frame mapping.
Output Signal
Defines the bit rate the output from the Tx port.
OTU1: 2.666 Gbit/s
OTU2: 10.709 Gbit/s
OTU1e: 11.049 Gbit/s
OTU2e: 11.096 Gbit/s
OTU1f: 11.270 Gbit/s
OTU2f: 11.318 Gbit/s
Client Signal
Defines the Client Signal. The available values change depending on the
output signal type.
PRBS: PRBS
NULL: Null
GbE: Giga bit Ethernet (1.25 Gbit/s)
10GbE: 10 Giga bit Ethernet (10.3125 Gbit/s)
Ethernet: Variable rate
STM64(Async): Synchronous Transport Module-64 (9953.28 Mbit/s)
STM64(Sync): Synchronous Transport Module-64 (9953.28 Mbit/s)
STM16(Async): Synchronous Transport Module-16 (2488.32 Mbit/s)
STM16(Sync): Synchronous Transport Module-16 (2488.32 Mbit/s)
STM4: Synchronous Transport Module-4 (622.08 Mbit/s)
STM1: Synchronous Transport Module-1 (155.52 Mbit/s)
FC100: Fibre Channel 100 Mbyte/s (1.0625 Gbit/s)
FC200: Fibre Channel 200 Mbyte/s (2.125 Gbit/s)
FC400: Fibre Channel 400 Mbyte/s (4.25 Gbit/s)
FC800: Fibre Channel 800 Mbyte/s (8.5 Gbit/s)
614.4 M(CPRI): CPRI Option 1 (614.4 Mbit/s)
1228.8 M(CPRI): CPRI Option 2 (1228.8 Mbit/s)
2457.6 M(CPRI): CPRI Option 3 (2457.6 Mbit/s)
3072.0 M(CPRI): CPRI Option 4 (3072.0 Mbit/s)
4915.2 M(CPRI): CPRI Option 5 (4915.2 Mbit/s)
6144.0 M(CPRI): CPRI Option 6 (6144.0 Mbit/s)
9830.4 M(CPRI): CPRI Option 7 (9830.4 Mbit/s)
GbE through Ethernet appear if the application is Ethernet on OTN.
STM64(Async) through STM1 appear if the application is SDH/SONET on
OTN.
FC100 through FC800 appear if the application is Fibre Channel on OTN.
614.4 M(CPRI) through 9830.4 M(CPRI) appear if the application is CPRI on
OTN.
Multiplexing 1
Applicable when there are two or more levels of multiplexing. Defines into
which higher order the second level ODU is mapped.
None
ODTU12 (PT=20) : Supports 2.5G Tributary Slot (TS).
To Next Page
Loading...
