Cisco Nexus 7000 Series - Page 220

F Commands
filter frame-type fcoe
192
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
filter frame-type fcoe
To configure the Fibre Channel over Ethernet (FCoE) frame type filter for the Ethernet Switched Port
Analyzer (SPAN) or Encapsulated Remote Switched Port Analyzer (ERSPAN) session, use the filter
frame-type fcoe command. To remove the FCoE frame type filter, use the no form of this command.
filter frame-type fcoe [[fc-sid FC-source-ID] [fc-did FC-dest-ID] [fcoe-type fcoe-value] [r-ctl
r-ctl-value] [sof sof-value] [cmd-code cmd-value]]
no filter frame-type fcoe [[fc-sid FC-source-ID] [fc-did FC-dest-ID] [fcoe-type fcoe-value] [r-ctl
r-ctl-value] [sof sof-value] [cmd-code cmd-value]]
Syntax Description
Defaults None
Command Modes config-monitor mode (for a SPAN session)
config-erspan-src mode (for an ERSPAN session)
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines F1 Series modules do not support FCoE source IDs and FCoE destination IDs.
This command does not require a license.
Examples This example shows how to configure the FCoE frame type filter for a SPAN session:
switch(config)# monitor session 1
switch(config-monitor)# filter frame-type fcoe
fc-sid
FC-source-ID
(Optional) Specifies a filter based on an FC source ID.
fc-did FC-dest-ID (Optional) Specifies a filter based on an FC destination ID.
fcoe-type
fcoe-value
(Optional) Specifies a filter based on an FCoE type.
r-ctl r-ctl-value (Optional) Specifies a filter based on the routing control flags (R CTL) value.
sof sof-value (Optional) Specifies a filter based on the start of frame (SOF) packets.
cmd-code
cmd-value
(Optional) Specifies a filter based on a command code.
Release Modification
6.2(2) This command was introduced.