F Commands
filter frame-type fcoe
193
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
This example shows how to configure the FCoE frame type filter for an ERSPAN session:
switch(config)# monitor session 1 type erspan-source
switch(config-erspan-src)# filter frame-type fcoe fc-did 2
Related Commands Command Description
filter (ERSPAN) Configures the filters for an ERSPAN session.
filter (SPAN) Configures the filters for a SPAN session.
filter frame-type arp Configures the ARP frame type filter for the ERSPAN session.
filter frame-type eth Configures the FCoE frame type filter for the SPAN or ERSPAN session.
filter frame-type ipv4 Configures the IPv4 frame type filter for the SPAN or ERSPAN session.
filter frame-type ipv6 Configures the IPv6 frame type filter for the SPAN or ERSPAN session.
monitor session Places you in the monitor configuration mode for configuring a SPAN or
ERSPAN session.
To Next Page
Loading...
