H Commands
hw-module logging onboard
213
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
This configuration command is applicable to the module inserted in a device. When the module is
removed and inserted into a new device, the configuration of this command follows the module to the
new device.
This command does not require a license.
Examples This example shows how to configure OBFL message logging at level 7 (debugging):
Router> enable
switch# configure terminal
switch(config)# hw-module switch 2 module 1 logging onboard message level 7
switch(config)# end
Related Commands Command Description
attach Connects to a specific line card for the purpose of
executing commands on that card.
clear logging onboard Clears onboard failure logs.
show logging onboard Displays onboard failure logs.
To Next Page
Loading...
