Cisco Nexus 7000 Series - Page 46

A Commands
alert-group
18
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
alert-group
To configure a Call home CLI command for an alert group, use the alert-group command. To remove
the command from the alert group, use the no form of this command.
alert-group {All | Configuration | Diagnostic | EEM |Environmental | Inventory | License |
Linecard-Hardware | Supervisor-Hardware | Syslog-group-port | System | Tes t}
user-def-cmd cli_command
no alert-group {All | Configuration | Diagnostic | Environmental | Inventory | License |
Linecard-Hardware | Supervisor-Hardware | Syslog-group-port | System | Tes t}
user-def-cmd cli_command
Syntax Description
Defaults None
Command Modes Call home configuration
Supported User Roles network-admin
vdc-admin
All Specifies all alert groups—configuration, diagnostic, EEM, environmental,
inventory, license, linecard-hardware, supervisor-hardware, syslog-group-port,
system, and test.
Configuration Specifies events related to configurations.
Diagnostic Specifies events related to diagnostics.
EEM Specifies events related to EEM.
Environmental Specifies events related to power,fan,temperature related events.
Inventory Specifies events related to the inventory status.
License Specifies events related to license.
Linecard-
Hardware
Specifies events related to line card hardware.
Supervisor-
Hardware
Specifies events related to the supervisor module.
Syslog-group-
port
Specifies events related to syslog messages filed by port manager.
System Specifies events related to software.
Test Specifies events related to tests.
user-def-cmd
cli_command
Configures a valid CLI command for the alert group.