Cisco Nexus 7000 Series - Page 532

Show Commands
show hardware flow
504
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
show hardware flow
To display information about NetFlow hardware IP flows, use the show hardware flow ip command.
show hardware flow {ip | ipv6} [interface type number | monitor monitor-name | profile profile-id
| vdc vdc-name | vlan vlan-name] [detail] [module module]
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines You must have already enabled traffic monitoring with Flexible NetFlow before you can use the
show
hardware flow ip command.
This command does not require a license.
Examples This example shows how to display the NetFlow aging values for module 8:
switch(config)# show hardware flow ip module 8
ip Displays information about the IP flows.
ipv6 Displays information about the IPv6 flows.
interface interface-type
number
(Optional) Specifies the type of interface that you want to view Flexible
NetFlow accounting configuration information on.
monitor monitor-name (Optional) Specifies the name of the flow monitor. The monitor name can be
any case-sensitive, alphanumeric string up to 64 characters.
profile profile-id (Optional) Specifies the name of the flow profile. The profile ID range is
from 0 to 31.
vdc vdc-name (Optional) Specifies the virtual device context (VDC) name. The VDC name
can be any case-sensitive, alphanumeric string up to 64 characters.
detail (Optional) Displays detailed information about the flows.
module slot-number (Optional) Displays information specific to a module.
Release Modification
4.0(1) This command was introduced.