D-Link DGS-3000 - Page 405

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
401
Format
clear igmp_snooping data_driven_group [all | [vlan_name <vlan_name> | vlanid
<vlanid_list>] [<ipaddr> | all]]
Parameters
all - Specify all VLANs to which IGMP snooping groups will be deleted.
vlan_name - Specify the VLAN name.
<vlan_name> - Enter the VLAN name here.
vlanid - Specify the VLAN ID.
<vlanid_list> - Enter the VLAN ID here.
<ipaddr> - Enter the group’s IP address learned by data driven.
all - Deletes all IGMP snooping groups of specified VLANs.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To delete all the groups learned by data-driven:
DGS-3000-26TC:admin#clear igmp_snooping data_driven_group all
Command: clear igmp_snooping data_driven_group all
Success.
DGS-3000-26TC:admin#
show igmp_snooping 38-16
Description
This command is used to display the current IGMP snooping configuration on the Switch.
Format
show igmp_snooping {[vlan <vlan_name 32> | vlanid <vlanid_list>]}
Parameters
vlan - (Optional) Specify the name of the VLAN for which you want to view the IGMP snooping
configuration.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - (Optional) Specify the ID of the VLAN for which you want to view the IGMP snooping
configuration.
<vlanid_list> - Enter the VLAN ID list here.
If the VLAN is not specified, the system will display all current IGMP snooping configurations.