DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
433
DGS-3000-26TC:admin#show address_binding nd_snoop binding_entry
Command: show address_binding nd_snoop binding_entry
S (Status) - A: Active, I: Inactive
Time - Left Time (sec)
IP Address MAC Address S LT(sec) Port
--------------------------------------- ----------------- -- ---------- -----
2001:2222:1111:7777:5555:6666:7777:8888 00-00-00-00-00-02 I 50 5
2001::1 00-00-00-00-03-02 A 100 6
Total Entries : 2
clear address_binding nd_snoop binding_entry ports 39-22
Description
This command is used to clear the ND snooping entries on specified ports.
Format
clear address_binding nd_snoop binding_entry ports [<portlist> | all]
Parameters
<portlist> - Enter the list of ports that you would like to clear the ND snoop learned entry.
all - Specify to clear all ND snooping learned entries.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To clear ND snooping entry on ports 1-3:
DGS-3000-26TC:admin#clear address_binding nd_snoop binding_entry ports 1-3
Command: clear address_binding nd_snoop binding_entry ports 1-3
Success.
enable address_binding trap_log 39-23
Description
This command is used to send traps and logs when the IMPB module detects an illegal IP and
MAC address.
To Next Page