D-Link DGS-3000 - Page 439

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
435
DGS-3000-26TC:admin#disable address_binding trap_log
Command: disable address_binding trap_log
Success.
DGS-3000-26TC:admin#
config address_binding recover_learning 39-25
Description
This command is used to recover IMPB checking.
Format
config address_binding recover_learning ports [<portlist> | all]
Parameters
ports - Specify the list of ports that need to recover the IMPB check.
<portlist> - Enter the list of port used here.
all - Specify that all the ports will be used.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To recover IMPB checking for ports 6 to 7:
DGS-3000-26TC:admin#config address_binding recover_learning ports 6-7
Command: config address_binding recover_learning ports 6-7
Success.
DGS-3000-26TC:admin#
debug address_binding 39-26
Description
This command is used to start the IMPB debug when the IMPB module receives an ARP/IP packet
or a DHCP packet.
Format
debug address_binding [event | dhcp | all] state [enable | disable]