DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
436
Parameters
event - Prints out the debug messages when IMPB module receives ARP/IP packets.
dhcp - Prints out the debug messages when the IMPB module receives the DHCP packets.
all - Prints out all debug messages.
state - Specify the IMPB debug state to be enabled or disabled.
enable - Specify to enable the state.
disable - Specify to disable the state.
Restrictions
Only Administrator users can issue this command.
Example
To print out all debug IMPB messages:
DGS-3000-26TC:admin#debug address_binding all state enable
Command: debug address_binding all state enable
Success.
no debug address_binding 39-27
Description
This command is used to stop the IMPB debug starting when the IMPB module receives an
ARP/IP packet or a DHCP packet.
Format
no debug address_binding
Parameters
None.
Restrictions
Only Administrator users can issue this command.
Example
To stop IMPB debug: starting when the IMPB module receives an ARP/IP or DHCP packet:
To Next Page