D-Link DGS-3000 - Page 539

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
535
Parameters
mac - (Optional) Displays MAC-based Access Control local database entries for a specific MAC
address.
<macaddr> - Enter the MAC address used here.
vlan - (Optional) Displays MAC-based Access Control local database entries for a specific target
VLAN name.
<vlan_name 32> - Enter the VLAN name here. This name can be up to 32 characters long.
vlanid - (Optional) Displays MAC-based Access Control local database entries for a specific
target VLAN ID.
<vlanid 1-4094> - Enter the VLAN ID here. This value must be between 1 and 4094.
If the parameter is no specified, displays all MAC-based Access Control local database entries.
Restrictions
None.
Example
To show MAC-based Access Control local database for the VLAN called ‘default’:
DGS-3000-26TC:admin#show mac_based_access_control_local vlan default
Command: show mac_based_access_control_local vlan default
MAC Address VID
----------------- ----
00-00-00-00-00-01 1
00-00-00-00-00-04 1
Total Entries:2
DGS-3000-26TC:admin#
show mac_based_access_control auth_state 49-17
Description
This command is used to display the MAC-based Access Control authentication status.
Format
show mac_based_access_control auth_state ports {<portlist>}
Parameters
ports - Displays authentication status by specific port.
<portlist> - (Optional) Enter the list of port used for this configuration here.
If not specified port(s), it will display all of MAC-based Access Control ports authentication status.
Restrictions
None.