D-Link DGS-3000 - Page 540

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
536
Example
To display the MAC-based Access Control authentication status on port 1-4
DGS-3000-26TC:admin#show mac_based_access_control auth_state ports 1-4
Command: show mac_based_access_control auth_state ports 1-4
(P): Port-based
Port MAC Address State VID Priority Aging Time/
Block Time
---- -------------------- -------------- ---- -------- ------------
Total Authenticating Hosts : 0
Total Authenticated Hosts : 0
Total Blocked Hosts : 0
DGS-3000-26TC:admin#
config mac_based_access_control max_users 49-18
Description
This command is used to configure the maximum number of authorized clients.
Format
config mac_based_access_control max_users [<value 1-1000> | no_limit]
Parameters
max_users - Specify to set the maximum number of authorized clients on the whole device.
<value 1-1000> - Enter the maximum users here. This value must be between 1 and 1000.
no_limit - Specify to not limit the maximum number of users on the system. By default, there
is no limit on the number of users.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the maximum number of users of the MAC-based Access Control system supports to
128:
DGS-3000-26TC:admin#config mac_based_access_control max_users 128
Command: config mac_based_access_control max_users 128
Success.
DGS-3000-26TC:admin#