SV-ADAHRS-200/201 Installation and Configuration
SkyView System Installation Guide - Revision AA 5-9
Figure 48 – SV-ADAHRS-200/201 Mounting Dimensions with Electronic and Pneumatic Connections
An SV-ADAHRS-200/201 should be mounted within one degree of parallel to all three aircraft
axes, with the pneumatic fittings facing toward the front of the aircraft.
To ensure that the Slip/Skid Ball will be displayed as centered during flight, the SV-
ADAHRS-200/201 must be installed to 0° (absolute level). There is no adjustment in
SkyView to electronically level the SV-ADAHRS-200/201. If, after installation, the
Slip/Skid Ball is not centered, you will need to shim the SV-ADAHRS-200/201 to be
0° (absolute level). During installation, it may be necessary to use an electronic
level as a “spirit” or “bubble” level may not be able to display an accurate enough
degree of level.
The module’s mounting tabs must be on the bottom. The label must be on the top. Figure 48
shows the correct orientation of the ADAHRS as it would appear if you were above the aircraft,
looking down at it. The module will not operate properly if it is rotated or inverted in any other
orientation.
To Next Page
Loading...
