SV-ARINC-429 Installation and Configuration
SkyView System Installation Guide - Revision AA 12-9
Out: High | GAMA Format 2
SDI: Common
"VOR/LOC/GS Configuration Page
Nav Radio: Enabled
ARINC 429 Configuration:
TX Speed: High
SDI: Common
Other Settings: Unused by SkyView
“RS-232 Configuration” Page
RS232 1 Output: Aviation Output 1
Optional (ADS-B)
If a Dynon Avionics SV-XPNDR-261 is being used for ADS-B Out capability: Another GTN serial
output should be set to “ADS-B+ OUT” format. That serial port should be connected to the SV-
XPNDR-261’s pin 3 through a 1.21k resistor as described in SV-XPNDR-261/262 Installation and
Configuration. Finally, set SETUP > TRANSPONDER SETUP > GPS DATA to DIRECT (GARMIN ADS-
B/ADS-B+).
SkyView Settings
SETUP MENU > SYSTEM SETUP > ARINC-429:
(Configure MODULE 1 and MODULE 2 independently)
> INPUT SPEED: HIGH
> INPUT 1: GPS X
> NAVIGATION SOURCE DISP NAME: (user selectable, 7 characters. The name entered here is
displayed as the HSI source and the Flight Plan Source (if this device outputs a flight plan).
> INPUT 2: NAV X
> NAVIGATION SOURCE DISP NAME: (user selectable, 7 characters. The name entered here is
displayed as the HSI source and the Flight Plan Source (if this device outputs a flight plan).
> OUTPUT SPEED: HIGH
> ALLOW AUTO SWITCH: YES (LABEL 100P)
Setting ALLOW AUTO SWITCH: to YES (LABEL 100P) (which is the default, including after
upgrading Software to v10.0 or later) allows the GTN to tell SkyView to switch from GPS to ILS
or back when on an ILS overlay approach - SkyView will display whatever mode the GTN tells
SkyView to be in. When in this mode and not on an approach, switching between the NAV
function and GPS function must be performed from the GTN.
If you want to manually select GPS and NAV from the GTN, as you have done prior to v10.0,
SETUP MENU > SYSTEM SETUP > ARINC-429 > ALLOW AUTO SWITCH: NO.
To Next Page
Loading...
