Dynon Avionics SkyView Classic - Page 536

Appendix I: SkyView System Installation Guide Revision History
29-6 SkyView System Installation Guide - Revision AA
Revision
Revision Date
Description
o Hardware Support Change Only: Maintenance release to support internal
hardware change. There are no bug fixes, feature additions, or
documentation changes for this release from 3.2.0.
 Added angle of attack menu item.
 Added OAT sensor adjustment setting information.
 Added Vertical Power VP-X License information and interfacing information.
 Clarified serial port connections for multi-display SkyView systems in Appendix E.
 Added information about which modules and devices the SV-BAT-320 can provide
power to in the event of power failure.
 Added EI FT-60 fuel flow sensor orientation information.
 Added a note about the importance of external devices sharing ground with SkyView
for proper operation.
 Added Amps shunt fuse diagram.
 Added SV-XPNDR-261/262 power wire size recommendation.
 Added permission to print manual.
 Added information about taking screenshots for troubleshooting purposes.
 Added information about re-doing ADAHRS-based calibrations if an additional ADAHRS
is installed after calibrations have been done.
 Consolidated all information about ADAHRS calibrations into the ADAHRS installation
section.
 Added ADAHRS, SYSTEM, and NMEA Serial output information to Serial Data Output
Appendix.
 262 pages
J
November, 2011
 Document number changed to 101320-009
 Software changes in SkyView Software v3.2.2:
o Added: Garmin GTN series ARINC support.
o Improved: G-meter behavior above 1.5G.
o Improved: Garmin 430/530 series ARINC support.
o Fixed: VP-X flaps controls backwards.
o Fixed: VP-X vulnerability that can cause a trim or flaps runaway condition
after a momentary press of the flaps or trim UP/DOWN/LEFT/RIGHT
buttons.
 Added Garmin GTN connection information.
 Added Garmin serial port setting for Garmin 430/530 ARINC-429 based connections.
 264 pages
K
March, 2012
 Document number changed to 101320-010
 Software changes in SkyView Software 3.3:
o Added: Audio output/alerts. See the technical advisory page for information
about an audio output hardware issue that affects the audio quality of
some SkyView display units.
o Added: Zero Pressure Airspeed Calibration routine for best possible
accuracy at very low indicated airspeeds.
o Added: Alerts for various required calibrations (mag heading, AOA, etc.),
especially when a new seconds ADAHRS is added or replaced.
o Added: Rotax 912 special oil temp and tachometer behaviors (variable
redlines based on oil temperature).
o Added: Robust User Waypoints feature within SkyView.
o Added: Ability to inhibit engine alerts after boot but before engine is
started.
o Added: Support for Visual Reporting Points in navigation mapping software.
o Added: Altitude Alerter.
o Added: Support for more configurable info items on the map page.
o Improved: Alert / messaging infrastructure and UI completely refreshed.
o Improved: Airspeed tape made wider better color marking visibility.
o Improved: Map / navigation mapping software user interface.
o Fixed: Map now supports 7-character airport identifiers that exist in some
databases.
o Fixed: Bug that could cause some EGTs or CHTs to not alarm properly after
complex configuration changes.
o Fixed: Reversed runways in PocketFMS data.
 Software changes in SkyView Software v3.3.1 released April 4, 2012 (no
documentation changes):
o No feature changes: Minor bug fix for OEM-specific features.