o Improved: Automatic detection and restart for issues that would previously
cause SkyView displays to become unresponsive. This will also generate a
SYSTEM EVENT that will ask the user to export a Dynon Diagnostic Log.
o Added: New SYSTEM EVENT alerts that let SkyView detect additional
software anomalies. Upon seeing a SYSTEM EVENT alert, users should enter
the Setup Menu for more information and instructions.
Software changes in SkyView Software v14.0.1.3558, released 2016-02-18:
o Public Test Version
o Improved: The diagnostic logging capabilities added in 14.0.1 now collects
improved data about anomalies. There are no behavior changes or new
SYSTEM EVENT alerts over 14.0.1.
Software changes in SkyView Software v14.0.3.3563, released 2016-02-23:
o Public Test Version
o Improved: The diagnostic logging capabilities added in 14.0.1.3558 have
been further enhanced. Automatic recovery (rebooting) behavior tweaked
to be less aggressive. There are no other new features or new SYSTEM
EVENT alerts over 14.0.1.
Software changes in SkyView Software v14.0.5.3594, released 2016-02-26:
o Public Test Version
o Improved: Fixes to various suspicious code areas that may or may not be
the cause of the 14.0 issue. There are no other new features or new
SYSTEM EVENT alerts over 14.0.1.
Software changes in SkyView Software v14.0.6.3609, released 2016-03-04:
o Public Test Version
o Potential Fix: Dynon Avionics believes that it has identified the issue that is
the subject of Technical Service Bulletin - SkyView Software 14.0. This
version contains a candidate fix. There are no other new features over
previous versions.
Software changes in SkyView Software v14.0.7.3621, released 2016-03-10:
o Public Test Version
o Potential Fix: Probable fix for customers reporting momentary "Red X"
pages, uncommanded autopilot disconnects, and audio caution alerts.
There are no other new features over previous versions.
New products included in this revision:
o SV-BUTTON-LEVEL Autopilot LEVEL button (Page 10-12)
o SV-GPS-2020 GPS Antenna/Receiver Module (High Integrity GPS - meets
FAA 2020 ADS-B Out requirements)
o SV-HARNESS-ADSB Harness for SV-ADSB-470
o SV-HARNESS-XPNDR Harness for SV-XPNDR-261/262
o SV-XPNDR-261/262 Software v2.08
New features included in v14.0:
o Support for External GO AROUND Button (SkyView Display(s) CONTACT
INPUT 2, Pin 27)
o For US registered aircraft, when TAIL NUMBER is set, TRANSPONDER HEX
CODE is computed and set automatically (Page 4-31 and Page 11-19)
o Checklists (Appendix K)
Documentation added:
o System Event 5 error (Page 21-2)
o Appendix H: Sensor Debug Data
o Appendix I: SkyView System Installation Guide Revision
History. Information on revisions prior to current was relocated there.
o Incorporated Software changes from What’s New in SkyView Software
concurrent for each SkyView System Installation Guide Revision (Appendix I:
SkyView System Installation Guide Revision History)
o Appendix J: Checklists
Documentation improved:
o Location Requirements for individual units / subsystems relocated from
System Planning to the installation section for that unit.
o Added current requirement for SV-INTERCOM-2S to Table 3 (page 2-3).
o Updated Table 7 – HSI Requirements (Page 2-15)
o Section 8 (SV-GPS-250/2020) extensively rewritten to incorporate SV-GPS-
2020 and SV-GPS-250 SIL/SDA=1.
To Next Page
Loading...
