Endress+Hauser Proline Promag 300 - Failure Value; Status Input 1 to N Submenu; Status Input 1 to N; Expert → Input → Current Input 1 to N

Description of device parameters Proline Promag 300 Modbus RS485
102 Endress+Hauser
Failure value 
Navigation  Expert → Input → Current input 1 to n → Failure value (1602–1 to n)
Prerequisite In the Failure mode parameter (→  101), the Defined value option is selected.
Description Use this function to enter the value that the device uses if it does not receive an input
signal from the external device, or if the input signal is invalid.
User entry Signed floating-point number
Factory setting 0
3.4.2 "Status input 1 to n" submenu
Navigation  Expert → Input → Status input 1 to n
‣
Status input 1 to n
Terminal no. (1358–1 to n)
→  102
Assign stat.inp. (1352–1 to n)
→  103
Val.stat.inp. (1353–1 to n)
→  103
Active level (1351–1 to n)
→  104
Response time (1354–1 to n)
→  104
Terminal no.
Navigation  Expert → Input → Status input 1 to n → Terminal no. (1358–1 to n)
Description Displays the terminal numbers used by the status input module.
User interface • Not used
• 24-25 (I/O 2)
• 22-23 (I/O 3)
Additional information "Not used" option
The status input module does not use any terminal numbers.