Endress+Hauser Proline Promag 300 - 100% Bargraph 1; Decimal Places 1 (0095)

Proline Promag 300 Modbus RS485 Description of device parameters
Endress+Hauser 19
Description Use this function to enter the 0% bar graph value to be shown on the display for the
measured value 1.
User entry Signed floating-point number
Factory setting Country-specific:
• 0 l/h
• 0 gal/min (us)
Additional information Description
The Format display parameter (→  16) is used to specify that the measured value
is to be displayed as a bar graph.
User entry
The unit of the displayed measured value is taken from the System units submenu
(→  55).
100% bargraph 1 
Navigation  Expert → System → Display → 100% bargraph 1 (0125)
Prerequisite A local display is provided.
Description Use this function to enter the 100% bar graph value to be shown on the display for the
measured value 1.
User entry Signed floating-point number
Factory setting Depends on country and nominal diameter →  212
Additional information Description
The Format display parameter (→  16) is used to specify that the measured value
is to be displayed as a bar graph.
User entry
The unit of the displayed measured value is taken from the System units submenu
(→  55).
Decimal places 1 
Navigation  Expert → System → Display → Decimal places 1 (0095)
Prerequisite A measured value is specified in the Value 1 display parameter (→  18).
Description Use this function to select the number of decimal places for measured value 1.