Endress+Hauser Proline Promag 300 - Device ID; Device Revision; Modbus Info Submenu

Proline Promag 300 Modbus RS485 Description of device parameters
Endress+Hauser 155
Additional information Description
If read and/or write protection is enabled, the parameter can only be controlled and reset
via local operation. Access is no longer possible via operating tools.
This does not affect cyclic measured value transmission to the higher-order system,
which is always guaranteed.
Selection
• Read + write
The parameters are read and write parameters.
• Read only
• The parameters are read only parameters.
3.6.2 "Modbus info" submenu
Navigation  Expert → Communication → Modbus info
‣
Modbus info
Device ID (7153)
→  155
Device revision (7154)
→  155
Device ID
Navigation  Expert → Communication → Modbus info → Device ID (7153)
Description Displays the device ID for identifying the measuring device.
User interface 4-digit hexadecimal number
Device revision
Navigation  Expert → Communication → Modbus info → Device revision (7154)
Description Displays the device revision.
User interface 4-digit hexadecimal number