Endress+Hauser Proline Promag 300 - I;O Module 3 Submenu

Proline Promag 300 Modbus RS485 Description of device parameters
Endress+Hauser 189
3.8.9 "I/O module 3" submenu
Navigation  Expert → Diagnostics → I/O module 3
‣
I/O module 3
I/O 3 terminals
→  189
Software rev.
→  189
Build no. softw.
→  189
Bootloader rev.
→  190
I/O 1 terminals
Navigation  Expert → Diagnostics → I/O module 1 → I/O 1 terminals (3902–1)
Description Displays the terminal numbers used by the I/O module.
User interface • Not used
• 26-27 (I/O 1)
• 24-25 (I/O 2)
• 22-23 (I/O 3)
Software rev.
Navigation  Expert → Diagnostics → I/O module 3 → Software rev. (0072)
Description Use this function to display the software revision of the module.
User interface Positive integer
Build no. softw.
Navigation  Expert → Diagnostics → I/O module 3 → Build no. softw. (0079)
Description Displays the software build number of the module.
User interface Positive integer