Endress+Hauser Proline Promag 300 - Decimal Places 3 (0118); Value 4 Display

Proline Promag 300 Modbus RS485 Description of device parameters
Endress+Hauser 23
Decimal places 3 
Navigation  Expert → System → Display → Decimal places 3 (0118)
Prerequisite A measured value is specified in the Value 3 display parameter (→  21).
Description Use this function to select the number of decimal places for measured value 3.
Selection • x
• x.x
• x.xx
• x.xxx
• x.xxxx
Factory setting x.xx
Additional information Description
This setting does not affect the measuring or computational accuracy of the device.
The arrow displayed between the measured value and the unit indicates that the
device computes with more digits than are shown on the local display.
Value 4 display 
Navigation  Expert → System → Display → Value 4 display (0109)
Prerequisite A local display is provided.
Description Use this function to select one of the measured values to be shown on the local display.
Selection For the picklist, see the Value 2 display parameter (→  20)
Factory setting None