Endress+Hauser Proline Promag 300 - 3.3 I;O configuration submenu

Proline Promag 300 Modbus RS485 Description of device parameters
Endress+Hauser 97
Apply I/O config (3907)
→  98
Alteration code (2762)
→  98
I/O 1 to n terminals
Navigation  Expert → I/O config. → I/O 1 to n terminals (3902–1 to n)
Description Displays the terminal numbers used by the I/O module.
User interface • Not used
• 26-27 (I/O 1)
• 24-25 (I/O 2)
• 22-23 (I/O 3)
I/O 1 to n info
Navigation  Expert → I/O config. → I/O 1 to n info (3906–1 to n)
Description Displays information about the plugged in I/O module.
User interface • Not plugged
• Invalid
• Not configurable
• Configurable
• MODBUS
Additional information "Not plugged" option
The I/O module is not plugged in.
"Invalid" option
The I/O module is not plugged correctly.
"Not configurable" option
The I/O module is not configurable.
"Configurable" option
The I/O module is configurable.
"Fieldbus" option
The I/O module is configured for the fieldbus.