Endress+Hauser Proline Promag 300 - Pulse;Frequency;Switch Output

Description of device parameters Proline Promag 300 Modbus RS485
118 Endress+Hauser
Measur. curr. 1 to n
Navigation  Expert → Output → Curr.output 1 to n → Measur. curr. 1 to n (0366–1 to n)
Description Use this function to display the actual measured value of the output current.
User interface 0 to 30 mA
3.5.2 "Pulse/frequency/switch output 1 to n" submenu
Navigation  Expert → Output → PFS output 1 to n
‣
PFS output 1 to n
Terminal no. (0492–1 to n)
→  119
Signal mode (0490–1 to n)
→  120
Operating mode (0469–1 to n)
→  120
Assign pulse 1 to n (0460–1 to n)
→  122
Value per pulse (0455–1 to n)
→  122
Pulse width (0452–1 to n)
→  123
Measuring mode (0457–1 to n)
→  123
Failure mode (0480–1 to n)
→  124
Pulse output 1 to n (0456–1 to n)
→  125
Assign freq. (0478–1 to n)
→  126
Min. freq. value (0453–1 to n)
→  126
Max. freq. value (0454–1 to n)
→  127
Val. at min.freq (0476–1 to n)
→  127
Val. at max.freq (0475–1 to n)
→  128
Measuring mode (0479–1 to n)
→  128
Damping out. 1 to n (0477–1 to n)
→  129