Endress+Hauser Proline Promag 300 - Connection State; Gateway IP Addr.; Rec.sig.strength; Select Antenna

Proline Promag 300 Modbus RS485 Description of device parameters
Endress+Hauser 165
Select antenna 
Navigation  Expert → Communication → WLAN settings → Select antenna (2713)
Description Use this function to select whether the external or internal antenna is used for reception.
Selection • External antenna
• Internal antenna
Factory setting Internal antenna
Connection state
Navigation  Expert → Communication → WLAN settings → Connection state (2722)
Description The connection status is displayed.
User interface • Connected
• Not connected
Factory setting Not connected
Rec.sig.strength
Navigation  Expert → Communication → WLAN settings → Rec.sig.strength (2721)
Description Displays the signal strength received.
User interface • Low
• Medium
• High
Factory setting High
Gateway IP addr.
Navigation  Expert → Communication → WLAN settings → Gateway IP addr. (2719)
Description Use this function to enter the IP address of the gateway.
Factory setting 192.168.1.212