Endress+Hauser Proline Promag 300 - Assign Proc.var.

Description of device parameters Proline Promag 300 Modbus RS485
202 Endress+Hauser
Signal level (1356)
→  204
Curr.inp 1 to n sim. (1608–1 to n)
→  204
Value curr.inp 1 to n (1609–1 to n)
→  205
Curr.out. 1 to n sim. (0354–1 to n)
→  205
Value curr.out 1 to n (0355–1 to n)
→  205
FreqOutputSim 1 to n (0472–1 to n)
→  206
Freq value 1 to n (0473–1 to n)
→  206
Puls.outp.sim. 1 to n (0458–1 to n)
→  207
Pulse value 1 to n (0459–1 to n)
→  207
Switch sim. 1 to n (0462–1 to n)
→  207
Switch status 1 to n (0463–1 to n)
→  208
Relay out. 1 to n sim (0802–1 to n)
→  208
Switch status 1 to n (0803–1 to n)
→  209
Puls.outp.sim. (0988)
→  209
Pulse value (0989)
→  210
Dev. alarm sim. (0654)
→  210
Event category (0738)
→  211
Diag. event sim. (0737)
→  211
Assign proc.var. 
Navigation  Expert → Diagnostics → Simulation → Assign proc.var. (1810)
Description Use this function to select a process variable for the simulation process that is activated.
The display alternates between the measured value and a diagnostic message of the
"Function check" category (C) while simulation is in progress.
Selection • Off
• Volume flow
• Mass flow
• Correct.vol.flow