Endress+Hauser Proline Promag 300 - I;O Config. Submenu

Modbus RS485 Register Information Proline Promag 300 Modbus RS485
246 Endress+Hauser
"Variable adjust" submenu
Navigation: Expert → Sensor → Sensor adjustm. → Variable adjust
Parameter Register Data type Access Selection / User entry / User interface → 
Vol. flow offset (1831) 5521 to 5522 Float Read / Write Signed floating-point number 90
Vol. flow factor (1832) 5519 to 5520 Float Read / Write Positive floating-point number 90
Mass flow offset (1841) 5525 to 5526 Float Read / Write Signed floating-point number 91
Mass flow factor (1846) 5523 to 5524 Float Read / Write Positive floating-point number 91
Conduct. offset (1848) 5529 to 5530 Float Read / Write Signed floating-point number 91
Conduct. factor (1849) 5527 to 5528 Float Read / Write Positive floating-point number 92
Corr. vol offset (1866) 2044 to 2045 Float Read / Write Signed floating-point number 92
Corr. vol factor (1867) 2076 to 2077 Float Read / Write Positive floating-point number 92
Temp. offset (1868) 2046 to 2047 Float Read / Write Signed floating-point number 93
Temp. factor (1869) 2042 to 2043 Float Read / Write Positive floating-point number 93
"Calibration" submenu
Navigation: Expert → Sensor → Calibration
Parameter Register Data type Access Selection / User entry / User interface → 
Nominal diameter (2807) 2048 to 2057 String Read DNxx / x" 95
Cal. factor (6522) 2313 to 2314 Float Read Positive floating-point number 96
Zero point (6546) 2870 to 2871 Float Read Signed floating-point number 96
Cond. cal. fact. (6718) 19806 to 19807 Float Read 0.01 to 10 000 96
6.3.3 "I/O config." submenu
Navigation: Expert → I/O config.
Parameter Register Data type Access Selection / User entry / User interface → 
I/O 1 to n terminals (3902–1 to n) 1: 6541
2: 6542
3: 6543
4: 6544
Integer Read 0 = Not used
1 = 26-27 (I/O 1)
2 = 24-25 (I/O 2)
3 = 22-23 (I/O 3)
97
I/O 1 to n info (3906–1 to n) 1: 8659
2: 8660
3: 8661
4: 8662
Integer Read 1 = MODBUS
2 = Configurable
3 = Not configurable
254 = Not plugged
255 = Invalid
97
I/O 1 to n type (3901–1 to n) 1: 6417
2: 6418
3: 6419
4: 6420
Integer Read / Write 0 = Off
0 = Curr.output
*
0 = Current input
*
0 = Status input
*
0 = PFS output
*
98
Apply I/O config (3907) 8665 Integer Read / Write 0 = Yes
1 = No
98
Alteration code (2762) 6427 Integer Read / Write Positive integer 98
* Visibility depends on order options or device settings