Endress+Hauser Proline Promag 300 - 3 Description of device parameters

Proline Promag 300 Modbus RS485 Description of device parameters
Endress+Hauser 11
3 Description of device parameters
In the following section, the parameters are listed according to the menu structure of the
local display. Specific parameters for the operating tools are included at the appropriate
points in the menu structure.

Expert
Direct access (0106)
→  11
Locking status (0004)
→  12
Access status (0005)
→  13
Ent. access code (0003)
→  13
‣
System
→  14
‣
Sensor
→  44
‣
I/O config.
→  96
‣
Input
→  99
‣
Output
→  104
‣
Communication
→  149
‣
Application
→  166
‣
Diagnostics
→  171
Direct access 
Navigation  Expert → Direct access (0106)
Description Use this function to enter the access code to enable direct access to the desired parameter
via the local display. A parameter number is assigned to each parameter for this purpose.
User entry 0 to 65 535
Additional information User entry
The direct access code consists of a 5-digit number (at maximum) and the channel
number, which identifies the channel of a process variable: e.g. 00914-2. In the navigation
view, this appears on the right-hand side in the header of the selected parameter.