Description of device parameters Proline Promag 300 Modbus RS485
60 Endress+Hauser
Density unit
Navigation Expert → Sensor → System units → Density unit (0555)
Description Use this function to select the unit for the density.
Selection SI units
• g/cm³
• g/m³
• kg/l
• kg/dm³
• kg/m³
• SD4°C
• SD15°C
• SD20°C
• SG4°C
• SG15°C
• SG20°C
US units
• lb/ft³
• lb/gal (us)
• lb/bbl (us;liq.)
• lb/bbl (us;beer)
• lb/bbl (us;oil)
• lb/bbl (us;tank)
Imperial units
• lb/gal (imp)
• lb/bbl (imp;beer)
• lb/bbl (imp;oil)
Factory setting Country-specific:
• kg/l
• lb/ft³
Additional information Result
The selected unit applies for:
• External density parameter (→ 85)
• Fixed density parameter (→ 85)
Selection
• SD = specific density
The specific density is the ratio of the medium density to the water density at a water
temperature of +4 °C (+39 °F), +15 °C (+59 °F), +20 °C (+68 °F).
• SG = specific gravity
The specific gravity is the ratio of the medium density to the water density at a water
temperature of +4 °C (+39 °F), +15 °C (+59 °F), +20 °C (+68 °F).
For an explanation of the abbreviated units: → 217
Cor.volflow unit
Navigation Expert → Sensor → System units → Cor.volflow unit (0558)
Description Use this function to select the unit for the corrected volume flow.
To Next Page
Loading...
