Endress+Hauser Proline Promag 300 - Assign Diag. Beh; Assign Status

Proline Promag 300 Modbus RS485 Description of device parameters
Endress+Hauser 141
• Conductivity
*
• CorrConductivity
*
• Totalizer 1
• Totalizer 2
• Totalizer 3
• Temperature
*
• Electronic temp.
Factory setting Volume flow
Assign diag. beh 
Navigation  Expert → Output → Relay output 1 to n → Assign diag. beh (0806–1 to n)
Prerequisite In the Relay outp.func. parameter (→  139), the Diag. behavior option is selected.
Description Use this function to select the category of the diagnostic events that are displayed for the
relay output.
Selection • Alarm
• Alarm or warning
• Warning
Factory setting Alarm
Additional information Description
If no diagnostic event is pending, the relay output is closed and conductive.
Selection
• Alarm
The relay output signals only diagnostic events in the alarm category.
• Alarm or warning
The relay output signals diagnostic events in the alarm and warning category.
• Warning
The relay output signals only diagnostic events in the warning category.
Assign status 
Navigation  Expert → Output → Relay output 1 to n → Assign status (0805–1 to n)
Prerequisite In the Relay outp.func. parameter (→  139), the Digital Output option is selected.
Description Use this function to select the device status for the relay output.
Selection • Partial pipe det
• Low flow cut off
* Visibility depends on order options or device settings