Endress+Hauser Proline Promag 300 - Empty Pipe Value; Full Pipe Value; Meas. Value EPD

Proline Promag 300 Modbus RS485 Description of device parameters
Endress+Hauser 81
Empty pipe value 
Navigation  Expert → Sensor → Process param. → Empty pipe det. → Empty pipe value (6527)
Prerequisite • In the Empty pipe det. parameter (→  79), the On option is selected.
• Adjustment value > full pipe value.
Description Displays the adjustment value when the measuring pipe is empty.
User interface Positive floating-point number
Full pipe value 
Navigation  Expert → Sensor → Process param. → Empty pipe det. → Full pipe value (6548)
Prerequisite • In the Empty pipe det. parameter (→  79), the On option is selected.
• Adjustment value < empty pipe value.
Description Displays the adjustment value when the measuring pipe is full.
User interface Positive floating-point number
Meas. value EPD
Navigation  Expert → Sensor → Process param. → Empty pipe det. → Meas. value EPD (6559)
Prerequisite In the Empty pipe det. parameter (→  79), the On option is selected.
Description Displays the current measured value.
User interface Positive floating-point number
"ECC" submenu
Navigation  Expert → Sensor → Process param. → ECC
‣
ECC
ECC (6528)
→  82
ECC duration (6555)
→  82
ECC recov. time (6556)
→  82