Endress+Hauser Proline Promag 300 - Additional Information; Decimal Places 4; Display Interval

Description of device parameters Proline Promag 300 Modbus RS485
24 Endress+Hauser
Additional information Description
If several measured values are displayed at once, the measured value selected here will be
the fourth value to be displayed. The value is only displayed during normal operation.
The Format display parameter (→  16) is used to specify how many measured
values are displayed simultaneously and how.
Selection
The unit of the displayed measured value is taken from the System units submenu
(→  55).
Custody transfer mode
Only available for Promag H.
Once the measuring device has been enabled for custody transfer mode, depending on the
custody transfer approval selected the display can switch to showing the custody transfer
counter.
For detailed information on custody transfer mode, see the Special Documentation for
the device →  7
Decimal places 4 
Navigation  Expert → System → Display → Decimal places 4 (0119)
Prerequisite A measured value is specified in the Value 4 display parameter (→  23).
Description Use this function to select the number of decimal places for measured value 4.
Selection • x
• x.x
• x.xx
• x.xxx
• x.xxxx
Factory setting x.xx
Additional information Description
This setting does not affect the measuring or computational accuracy of the device.
The arrow displayed between the measured value and the unit indicates that the
device computes with more digits than are shown on the local display.
Display interval
Navigation  Expert → System → Display → Display interval (0096)
Prerequisite A local display is provided.
Description Use this function to enter the length of time the measured values are displayed if the
values alternate on the display.