Endress+Hauser Proline Promag 300 - Confirm Code; Reset Acc. Code

Proline Promag 300 Modbus RS485 Description of device parameters
Endress+Hauser 41
Confirm code 
Navigation  Expert → System → Administration → Def. access code → Confirm code
Description Enter the defined release code a second time to confirm the release code.
User entry Max. 16-digit character string comprising numbers, letters and special characters
"Reset access code" submenu
Navigation  Expert → System → Administration → Reset acc. code
‣
Reset acc. code
Operating time (0652)
→  41
Reset acc. code (0024)
→  41
Operating time
Navigation  Expert → System → Administration → Reset acc. code → Operating time (0652)
Description Use this function to display the length of time the device has been in operation.
User interface Days (d), hours (h), minutes (m) and seconds (s)
Additional information User interface
The maximum number of days is 9999, which is equivalent to 27 years.
Reset acc. code
Navigation  Expert → System → Administration → Reset acc. code → Reset acc. code (0024)
Description Use this function to enter a reset code to reset the user-specific release code to the factory
setting.
User entry Character string comprising numbers, letters and special characters
Factory setting 0x00