Endress+Hauser Proline Promag 300 - Pressure Offset; Process Param. Submenu; Pressure Factor (0579)

Description of device parameters Proline Promag 300 Modbus RS485
70 Endress+Hauser
Additional information Result
The defined unit is shown as an option in the choose list of the Pressure unit
parameter.
Pressure offset 
Navigation  Expert → Sensor → System units → User-spec. units → Pressure offset (0580)
Description Use this function to enter the offset for adapting the user-specific pressure unit.
User entry Signed floating-point number
Factory setting 0
Pressure factor 
Navigation  Expert → Sensor → System units → User-spec. units → Pressure factor (0579)
Description Use this function to enter a quantity factor for the user-specific pressure unit.
User entry Signed floating-point number
Factory setting 1.0
Additional information Example
1 Dyn/cm² = 0.1 Pa → 10 Dyn/cm² = 1 Pa → user entry: 10
3.2.3 "Process param." submenu
Navigation  Expert → Sensor → Process param.
‣
Process param.
Filter options (6710)
→  71
Flow damping (6661)
→  73
Flow override (1839)
→  73
Conduct. measur. (6514)
→  74
Conduct. damping (1803)
→  74